Matt Gieselman | All posts tagged 'stripped-bolt'

Matt Gieselman

Tech, gadgets and more...

How to fix a stripped bolt hole

While restoring an old carburetor I found out that a couple of the bolt holes were stripped, the fix for this is a Heli-Coil kit.  The kits include a drill bit, tap, coils and an installer tool.  The basic steps are outlined below.

Here is a coil threaded on to a stud before installation, as you can see the 5/16-18 coil fits perfectly. heli_coil_0002
Next drill and tap the stripped hole using the drill bit and tap supplied in the kit.

Tip: Using a cutting oil or other light lubricant will make it easier to thread the new hole. 
Put the coil on the installer tool included in the kit, notice the tang going into the notch. heli_coil_0007
Carefully thread the coil into the hole that you just tapped. heli_coil_0008
The finished product is shown to the right. heli_coil_0006